Black, padded, and electrically heated vest from Back on Track, generating instant warmth with a simple button press - an essential for those who are a bit more prone to feeling cold, or for those who have simply grown tired of sitting and freezing on the riding arena bleachers. Also ideal to wear between riding sessions, to avoid losing warmth.
- Fully lined with Welltex® technology, which also reflects infrared energy
- Electric heating system with three different heat levels
- Rapid heating
- Lightweight
- Longer, lightly tailored fit with extra room for movement
- Two-way zipper
- Zipped pockets
Size & Fit
The product is generous in size, allowing for a thicker sweater underneath. However, if you prefer wearing it over only a thin layer of clothing and close to the body, consider going down a size.
Technical Specifications
- 5V/7.4V
- Three temperature levels - low (45°C), medium (50°C), or high (55°C)
- Powered by any 5V USB A power bank / 7.4V battery. Power bank not included.
Usage
1. Connect USB A / DC power bank
2. Press and hold the LED control for three seconds to turn on the system.
3. Press the LED control for 1 second to switch between settings (High/Medium/Low).
- Red LED light: Highest heat (55°C)
- White LED light: Medium (50°C)
- Blue LED light: Lowest heat (45°C)
To turn off, press and hold the LED control until the light goes out.
Welltex®
Welltex® technology's unique composition of natural minerals captures body heat and converts it into long-wave infrared energy, which is then reflected back to the skin, joints, and muscles. Infrared energy is known for its ability to promote blood circulation, and can therefore be helpful in recovery from injuries, wear and tear, inflammation, or tense muscles.
Starting with Back on Track
Back on Track's products with Welltex technology should be gradually introduced to accustom the body to the effect. The recommendation suggests a maximum of 4 hours/day for the first 2-3 days, then gradually increasing usage time by one hour at a time. Once the introductory period is over, the products should be used for at least 8 hours a day, preferably longer. It may take up to 10-20 days of use before achieving maximum results.
However, if you notice the effect starting to diminish, it may be good to take a break from the product. After the neutralization period, you can start again and reintroduce the product.
The products are ideally used directly in contact with the skin but also work effectively with a thin layer of fabric underneath. They can be used during both rest and activity - however, the best effect is achieved during activity, due to higher body temperature and therefore stronger heat reflection.
Use together with liniment or similar, with individual assessment, as the effect can be enhanced with simultaneous use.
Consider
An increased blood flow, in some cases, may have an effect that feels irritating or sore. The reaction is entirely individual, and everyone experiences the effect differently, but it's something useful to be aware of and attentive to, if necessary.
The initial reaction may occur after just an hour of use. If discomfort is experienced, the product should not be used more on the same day. Instead, try gradually introducing the product over the following days.
Use the product only as instructed and consult a doctor if symptoms persist. If undergoing medical treatment, it's advisable to consult your doctor if unsure how the product affects your treatment.
Avoid using during pregnancy or while expecting.
Care Instructions
For maximum effect, keep the product clean. The minerals providing the effect are embedded in the material and cannot be washed or worn off. Always follow the washing instructions on the product label.
- Hand wash only, 30°C
- Air dry
- No bleach
- No fabric softener
- No dry cleaning
- Do not tumble dry
- Do not wring out the garment
- Do not iron
Material
Outer fabric of polyamide. Inner lining, with Welltex®, made of polypropylene.
Lining and filling made of polyester.
